{"id":18621,"date":"2019-10-31T18:19:48","date_gmt":"2019-10-31T18:19:48","guid":{"rendered":"http:\/\/localhost\/bizhubtroubleshooter\/?post_type=epkb_post_type_1&p=18621"},"modified":"2023-12-18T14:30:48","modified_gmt":"2023-12-18T14:30:48","slug":"c0210-bizhub-287-227","status":"publish","type":"epkb_post_type_1","link":"https:\/\/apps.kmbizhubvcare.com\/bizhubtroubleshooter\/?epkb_post_type_1=c0210-bizhub-287-227","title":{"rendered":"C0210 (bizhub 287\/227)"},"content":{"rendered":"\n

Please search Knowledge Base articles and Bulletins as they may contain relevant information and updated Part information such as Part numbers.<\/strong><\/p>\n\n\n\n

Contents<\/h2>\n\n\n\n
Trouble type<\/td>C0210: LCT lift failure (When PC-413 is installed)<\/td><\/tr>
Rank<\/td>B<\/td><\/tr>
Trouble detection condition<\/td>-The main tray upper limit sensor (PS136) is not turned ON (blocked) even after the set period of time has elapsed after the paper lift-up operation for the drawer began.
-The shifter stop \/ lower limit position sensor (PS138) is not turned OFF (unblocked) even after the set period of time has elapsed after the paper lift-up operation for the drawer began.
-The main tray upper limit sensor (PS136) is not turned ON (blocked) even after the set period of time has elapsed after the paper lift-up operating.
-The main tray upper limit sensor (PS136) is not turned OFF (unblocked) even after the set period of time has elapsed after the paper lift-down operation began.
-The shifter stop \/ lower limit position sensor (PS138) is not turned ON (blocked) even after the set period of time has elapsed after the paper lift-down operation began.<\/td><\/tr>
Trouble isolation<\/td>Tray 3<\/td><\/tr>
Relevant electrical parts<\/td>-Elevator motor (M134)
-Main tray upper limit sensor (PS136)
-Shifter stop \/ lower limit position sensor (PS138)
-PC control board (PCCB)
-MFP board (MFPB)<\/td><\/tr><\/tbody><\/table>\n\n\n\n

 Procedure<\/h2>\n\n\n\n
  1. Check the connector between M134-PCCB CN10 for proper connection and correct as necessary.<\/li>
  2. Check the connector of M134 for proper drive coupling and correct as necessary.<\/li>
  3. Check the connector between PS136-relay CN1-PCCB CN4 for proper connection and correct as necessary.<\/li>
  4. Check the connector between PS138-relay CN16-PCCB CN14 for proper connection and correct as necessary.<\/li>
  5. PS136 I\/O check, sensor check