{"id":21937,"date":"2020-07-06T14:29:07","date_gmt":"2020-07-06T14:29:07","guid":{"rendered":"http:\/\/localhost\/bizhubtroubleshooter\/?post_type=epkb_post_type_1&p=21937"},"modified":"2023-12-13T17:43:10","modified_gmt":"2023-12-13T17:43:10","slug":"c0210-bizhub-650i-550i-450i","status":"publish","type":"epkb_post_type_1","link":"https:\/\/apps.kmbizhubvcare.com\/bizhubtroubleshooter\/?epkb_post_type_1=c0210-bizhub-650i-550i-450i","title":{"rendered":"C0210 (bizhub 650i\/550i\/450i)"},"content":{"rendered":"\n

Please search Knowledge Base articles and Bulletins as they may contain relevant information and updated Part information such as Part numbers.<\/strong><\/p>\n\n\n\n

Contents<\/h2>\n\n\n\n
Trouble type<\/td>C0210: Transfer LCT lift failure (When PC-416 is installed)<\/td><\/tr>
Rank<\/td>B<\/td><\/tr>
Trouble detection condition<\/td>-The main tray upper limit sensor (PS136) is not turned ON (blocked) even after the set period of time has elapsed after the paper lift-up operation for the main tray began.

-The shifter stop \/ lower limit position sensor (PS138) is not turned OFF (unblocked) even after the set period of time has elapsed after the paper lift-up operation for the drawer began.

-The main tray upper limit sensor (PS136) is not turned ON (blocked) even after the set period of time has elapsed after the paper lift-up operating.

-The main tray upper limit sensor (PS136) is not turned OFF (unblocked) even after the set period of time has elapsed after the paper lift-down operation began.

-The shifter stop \/ lower limit position sensor (PS138) is not turned ON (blocked) even after the set period of time has elapsed after the paper lift-down operation began.<\/td><\/tr>
Trouble isolation<\/td>LCT<\/td><\/tr>
Relevant electrical parts<\/td>-Main tray upper limit sensor (PS136)
-Shifter stop \/ lower limit position sensor (PS138)
-Elevator motor (M134)
-PC control board (PCCB)<\/td><\/tr><\/tbody><\/table>\n\n\n\n

Procedure<\/h2>\n\n\n\n
  1. Remove the tray<\/a>\u00a0and check to see if a piece of paper is not left inside the machine.<\/li>
  2. Check the connector between M134-PCCB CN10L for proper connection and correct as necessary.<\/li>
  3. Check the connector of M134 for proper drive coupling and correct as necessary.<\/li>
  4. Check the connector between PS136-relay CN1-PCCB CN4 for proper connection and correct as necessary.<\/li>
  5. Check the connector between PS138-relay CN16-PCCB CN14L for proper connection and correct as necessary.<\/li>
  6. PS136 I\/O check, sensor check