{"id":24274,"date":"2020-09-19T01:11:17","date_gmt":"2020-09-19T01:11:17","guid":{"rendered":"http:\/\/localhost\/bizhubtroubleshooter\/?post_type=epkb_post_type_1&p=24274"},"modified":"2023-12-13T16:14:02","modified_gmt":"2023-12-13T16:14:02","slug":"c8101-bizhub-360i-300i","status":"publish","type":"epkb_post_type_1","link":"https:\/\/apps.kmbizhubvcare.com\/bizhubtroubleshooter\/?epkb_post_type_1=c8101-bizhub-360i-300i","title":{"rendered":"C8101 (bizhub 360i\/300i)"},"content":{"rendered":"\n

Please search Knowledge Base articles and Bulletins as they may contain relevant information and updated Part information such as Part numbers.<\/strong><\/p>\n\n\n\n

Contents<\/h2>\n\n\n\n
Trouble type<\/td>C8101: Before reading pressure welding alienation mechanism (When DF-632 or DF-714 is installed)<\/td><\/tr>
Rank<\/td>B<\/td><\/tr>
Trouble detection condition<\/td><When\u00a0DF-632\u00a0is installed>
-During a pressure motion being performed, the reading roll position sensor (PS11) output does not change from H to L.

-During a retraction motion being performed, the reading roll position sensor (PS11) output does not change from L to H.<\/td><\/tr>
<\/td><When\u00a0DF-714\u00a0is installed>
-During a pressure motion being performed, the reading roll position sensor (PS4) output does not change from H to L.

-During a retraction motion being performed, the reading roll position sensor (PS4) output does not change from L to H. <\/td><\/tr>
Trouble isolation<\/td>DF<\/td><\/tr>
Relevant electrical parts<\/td><When\u00a0DF-632\u00a0is installed>
-Reading roll release motor (M5)
-Reading roll position sensor (PS11)
-DF control board (DFCB)<\/td><\/tr>
<\/td> <When\u00a0DF-714\u00a0is installed>
-Reading roll release motor (M4)
-Reading roll position sensor (PS4)
-DF control board (DFCB) <\/td><\/tr><\/tbody><\/table>\n\n\n\n

Procedure<\/h2>\n\n\n\n

When DF-632 is installed<\/p>\n\n\n\n

  1. Check the connector between M5-DFCB J18 for proper connection and correct as necessary.<\/li>
  2. Check the connector of M5 for proper drive coupling and correct as necessary.<\/li>
  3. Check the connector between PS11-DFCB J18 for proper connection and correct as necessary.<\/li>
  4. PS11 I\/O check, sensor check