{"id":25284,"date":"2023-09-26T13:34:33","date_gmt":"2023-09-26T13:34:33","guid":{"rendered":"https:\/\/apps.kmbizhubvcare.com\/bizhubtroubleshooter\/?post_type=epkb_post_type_1&p=25284"},"modified":"2023-12-13T14:35:08","modified_gmt":"2023-12-13T14:35:08","slug":"c0211-bizhub-950i-850i","status":"publish","type":"epkb_post_type_1","link":"https:\/\/apps.kmbizhubvcare.com\/bizhubtroubleshooter\/?epkb_post_type_1=c0211-bizhub-950i-850i","title":{"rendered":"C0211 (bizhub 950i\/850i)"},"content":{"rendered":"\n

Please search Knowledge Base articles and Bulletins as they may contain relevant information and updated Part information such as Part numbers.<\/strong><\/p>\n\n\n\n

Contents<\/strong><\/h2>\n\n\n\n
Trouble type<\/td>C0211: Manual feed up\/down abnormality<\/td><\/tr>
Rank<\/td>B<\/td><\/tr>
Trouble detection condition<\/td>– The bypass upper limit sensor (PS35) is not turned ON (blocked) even after the bypass lift-up motor (M28) rotates for a given period of time after the position is switched from stand by position at paper lift-up plate to the feed position.

– The bypass lower limit sensor (PS36) is not turned ON (blocked) even after the bypass lift-up motor (M28) rotates for a given period of time after the position is switched from stand by position at paper lift-up plate to the feed position.<\/td><\/tr>
Trouble isolation<\/td>Manual<\/td><\/tr>
Relevant electrical parts<\/td>– Bypass lift-up motor (M28)
– Bypass upper limit sensor (PS35)
– Bypass lower limit sensor (PS36)
– Bypass set sensor (PS30)
– Paper feed\/transport drive board (PFTDB)
– CPU board (CPUB)
– Base board (BASEB)<\/td><\/tr><\/tbody><\/table><\/figure>\n\n\n\n

Procedure<\/strong><\/h2>\n\n\n\n
    \n
  1. Check the connector between M28-relay CN195B-PFTDB CN9 for proper connection and correct as necessary.<\/li>\n\n\n\n
  2. Check the connector of M28 for proper drive coupling and correct as necessary.<\/li>\n\n\n\n
  3. Check the connector between PS35-relay CN195B-PFTDB CN9 for proper connection and correct as necessary.<\/li>\n\n\n\n
  4. Check the connector between PS30-relay CN195B-PFTDB CN9 for proper connection and correct as necessary.<\/li>\n\n\n\n
  5. Check the connector between PS36-relay CN180-relay CN195A-PFTDB CN3 for proper connection and correct as necessary.<\/li>\n\n\n\n
  6. Check CPUB for proper installation and correct as necessary.<\/li>\n\n\n\n
  7. PS30 I\/O check, sensor check\n