{"id":318,"date":"2019-04-22T19:52:20","date_gmt":"2019-04-22T19:52:20","guid":{"rendered":"http:\/\/localhost\/bizhubtroubleshooter\/?post_type=epkb_post_type_1&p=318"},"modified":"2023-12-27T18:18:21","modified_gmt":"2023-12-27T18:18:21","slug":"c0210-bizhub-c360i-c300i-c250i","status":"publish","type":"epkb_post_type_1","link":"https:\/\/apps.kmbizhubvcare.com\/bizhubtroubleshooter\/?epkb_post_type_1=c0210-bizhub-c360i-c300i-c250i","title":{"rendered":"C0210 (bizhub C360i\/C300i\/C250i)"},"content":{"rendered":"\n

Contents<\/h2>\n\n\n\n
Trouble type<\/td>C0210: Transfer LCT lift failure (When PC-416 is installed)<\/td><\/tr>
Rank<\/td>B<\/td><\/tr>
Trouble detection condition<\/td>\u2022The main tray upper limit sensor (PS136) is not turned ON (blocked) even after the set period of time has elapsed after the paper lift-up operation for the main tray began.
\u2022 The shifter stop \/ lower limit position sensor (PS138) is not turned OFF (unblocked) even after the set period of time has elapsed after the paper lift-up operation for the drawer began.
\u2022 The main tray upper limit sensor (PS136) is not turned ON (blocked) even after the set period of time has elapsed after the paper lift-up operating.
\u2022 The main tray upper limit sensor (PS136) is not turned OFF (unblocked) even after the set period of time has elapsed after the paper lift-down operation began.
\u2022 The shifter stop \/ lower limit position sensor (PS138) is not turned ON (blocked) even after the set period of time has elapsed after the paper lift-down operation began. <\/td><\/tr><\/tbody><\/table>\n\n\n\n
Trouble isolation<\/td>LCT<\/td><\/tr>
Relevant electrical parts<\/td>\u2022Main tray upper limit sensor (PS136)
\u2022 Shifter stop \/ lower limit position sensor (PS138)
\u2022 Elevator motor (M134)
\u2022 PC control board (PCCB)<\/td><\/tr><\/tbody><\/table>\n\n\n\n

Procedure<\/h2>\n\n\n\n
  1. Remove the tray<\/a> and check to see if a piece of paper is not left inside the machine.<\/li>
  2. Check the connector between M134-PCCB CN10L for proper connection and correct as necessary.<\/li>
  3. Check the connector of M134 for proper drive coupling and correct as necessary.<\/li>
  4. Check the connector between PS136-relay CN1-PCCB CN4 for proper connection and correct as necessary.<\/li>
  5. Check the connector between PS138-relay CN16-PCCB CN14L for proper connection and correct as necessary.<\/li>
  6. PS136 I\/O check, sensor check