10-02 (bizhub 364e/284e/224e)
Contents
| JAM type | Misfeed at manual bypass feed section |
| JAM code | 10-02 |
| Detection timing | For paper fed from the manual bypass, loop forming has not been complete before a sheet enters the registration roller because the rise timing of load to perform registration is earlier than the rise timing of load to form a loop. |
| – | In case paper position is detected as locating properly after main power switch is turned ON, door and cover are opened / closed or jam/trouble reset is done, it is regarded as paper jam at manual bypass feed section. |
| Misfeed processing location | Right door |
| Relevant parts | • Transport motor (M1)Registration clutch (CL4) • Bypass paper feed clutch (CL7) • Bypass pick-up solenoid (SD1) • Registration sensor (PS1) • Front side board (FRB) • Printer control board (PRCB) |
(2)Procedure
| Step | Action | Control signal | Location of electrical component |
| 1 | Initial check items | – | – |
| 2 | PS1 I/O check, sensor check | FRB CN8-3 (ON) | 4 to 5-L |
| 3 | CL4 operation check | FRB CN8-7 (CL4_24V) | 4-L |
| 4 | CL7 operation check | PRCB CN27-8 (ON) | 3-C |
| 5 | SD1 operation check | PRCB CN27-10 (ON) | 4-C |
| 6 | M1 operation check | PRCB CN31-2 (REM)PRCB CN31-5 (LOCK) | bizhub 364e 21-Jbizhub 284e 23-Jbizhub 224e 24-J |
| 7 | PRCB ICP5 conduction check | – | – |
| 8 | Replace FRB (Part# A61FH00500) | – | – |
| 9 | Replace PRCB (Part# A61FH00101) | – | – |
- Link to the wiring diagram (N.1. bizhub 364e/284e/224e)
Please search Knowledge Base articles and Bulletins as they may contain relevant information and updated Part information such as Part numbers.
K.1.6.1 (Link to the Field Service Manual)