10-02 (bizhub 554e/454e)
Contents
| JAM type | Misfeed at manual bypass feed section |
| JAM code | 10-02 |
| Detection timing | For paper fed from the manual bypass, loop forming has not been complete before a sheet enters the registration roller because the rise timing of load to perform registration is earlier than the rise timing of load to form a loop. |
| – | In case paper position is detected as locating properly after main power switch is turned ON, door and cover are opened / closed or jam/trouble reset is done, it is regarded as paper jam at manual bypass feed section. |
| Misfeed processing location | Right door |
| Relevant parts | • Paper feed motor (M22) • Registration motor (M24) • Bypass paper feed clutch (CL7) • Bypass pick-up solenoid (SD1) • Registration sensor (PS1) • Front side board (FRB) • Expansion control board (EXCB) • Printer control board (PRCB) |
(2)Procedure
| Step | Action | Control signal | Location of electrical component |
| 1 | Initial check items | – | – |
| 2 | PS1 I/O check, sensor check | FRB CN8-3 (ON) | 3-L |
| 3 | CL7 operation check | PRCB CN27-8 (ON) | 3-C |
| 4 | SD1 operation check | PRCB CN27-10 (ON) | 4-C |
| 5 | M22 operation check | EXCB CN3-5 to 8 | 22-P |
| 6 | M24 operation check | EXCB CN3-1 to 4 | 21-P |
| 7 | Replace FRB (Part# A61FH00500) | – | – |
| 8 | Replace EXCB (Part# A5AYH00501) | – | – |
| 9 | PRCB ICP5 conduction check | – | – |
| 10 | Replace PRCB (554e Part# A61EH00101 / 454e Part# A61DH00101) | – | – |
- Link to the wiring diagram (N.1. bizhub 554e/454e)
Please search Knowledge Base articles and Bulletins as they may contain relevant information and updated Part information such as Part numbers.
K.1.6.1 (Link to the Field Service Manual)