How Can We Help?
92-01, 92-02, 92-40 (bizhub 360i/300i)
Please search Knowledge Base articles and Bulletins as they may contain relevant information and updated Part information such as Part numbers.
Contents
| JAM type | Misfeed at duplex pre-registration section |
| JAM code | 92-01, 92-02, 92-40 |
| JAM detection timing | 92-01: The leading edge of the paper is not turned ON (unblocked) the registration sensor (PS1) even after the lapse of a given period of time after a duplex paper feed sequence has been started. |
| 92-02: For the second-side feed of paper in the duplex mode, loop forming has not been complete before the second side of a sheet enters the registration roller because the rise timing of load to perform registration is earlier than the rise timing of load to form a loop. | |
| 92-40: For the second-side feed of paper in the duplex mode, the image write start signal permit continues to be disabled for a predetermined period of time after the timing of the image write start signal output. | |
| – | Paper jam of a sheet of paper left at the duplex pre-registration section results, if a sheet of paper is determined to exist at a position detected when the main power switch is turned ON, a door is opened and closed, or a misfeed or malfunction is reset. |
| Misfeed processing location | Right door |
| Relevant parts | -Transport motor (M1) -ADU transport clutch (CL6) -Registration sensor (PS1) -Base board (BASEB) |
Procedure
| Step | Action | Control signal | Location of electrical component |
|---|---|---|---|
| 1 | Initial check items | – | – |
| 2 | PS1 I/O check, sensor check | BASEB CN15E-9 (ON) | 4-C |
| 3 | CL6 load check Check code: 81 Multi code: 0 | BASEB CN18E-1 (REM) | 5-C |
| 4 | M1 load check Check code: 40 Multi code: 1, 4, 5 | BASEB CN19E-1 to 5 | 1-C |
| 5 | Replace BASEB. (Part# AC77H02101) | – | – |