C0208 (bizhub 368/308)

Contents

Trouble type	C0208: Tray 4 feeder up/down abnormality (When PC-210 is installed)
Rank	B
Trouble detection condition	The tray 4 upper limit sensor (PS126) is not turned ON (blocked) even after the set period of time has elapsed after the paper lift-up operation for the drawer began.
Trouble isolation	Tray 4
Relevant electrical parts	• Tray 4 lift-up motor (M123) • Tray 4 upper limit sensor (PS126) • PC control board (PCCB) • MFP board (MFPB)

 Procedure

1. Remove the tray and check to see if a piece of paper is not left inside the machine.
2. Check the connector between M123-PCCB CN8 for proper connection and correct as necessary.
3. Check the connector of M123 for proper drive coupling and correct as necessary.
4. Check the connector between PS126-relay CN47-PCCB CN7 for proper connection and correct as necessary.
5. PS126 I/O check, sensor check
   • Control signal: PCCB CN7-3 (ON)
   • Location of electrical component: PC-210 8-K
6. M123 operation check
   • Control signal: PCCB CN8-8 to 9
   • Location of electrical component: PC-210 5-K
7. Replace M123. (Part# 9J06M10300)
8. Replace PCCB. (PC-110/PC-210) (Part# A2XMH00101/Part# A2XMH00201)
9. Replace MFPB. (Part# A9HJH02102)

NOTICE

• Link to the wiring diagram (PC-210)

Please search Knowledge Base articles and Bulletins as they may contain relevant information and updated Part information such as Part numbers.

K.3.7.9 (Link to the Field Service Manual)