C0214 (bizhub C287/C227)

Please search Knowledge Base articles and Bulletins as they may contain relevant information and updated Part information such as Part numbers.

Contents

Trouble type	C0214: LCT shift failure (When PC-414 is installed)
Rank	B
Trouble detection condition	-When the paper removal method and the correct paper setting method are displayed on the operation panel three times. -The shifter stop / lower limit position sensor (PS138) is not turned ON (blocked) even after the set period of time has elapsed after the shift operation began (shift to the right). -The shifter home sensor (PS139) is not turned OFF (unblocked) even after the set period of time has elapsed after the shift operation began (shift to the right). -The shifter stop / lower limit position sensor (PS138) is not turned OFF (unblocked) even after the set period of time has elapsed after the return operation began (shift to the left). -The shifter home sensor (PS139) is not turned ON (blocked) even after the set period of time has elapsed after the return operation began (shift to the left).
Trouble isolation	Tray 3
Relevant electrical parts	-Shifter stop / lower limit position sensor (PS138) -Shifter home sensor (PS139) -Shifter motor (M133) -PC control board (PCCB) -MFP board (MFPB)

 Procedure

1. Check the paper for proper set and correct as necessary.
2. Remove the tray and check to see if a piece of paper is not left inside the machine.
3. Check the connector between M133-PCCB CN10L for proper connection and correct as necessary.
4. Check the connector of M133 for proper drive coupling and correct as necessary.
5. Check the connector between PS138-relay CN16-PCCB CN14L for proper connection and correct as necessary.
6. Check the connector between PS139-relay CN16-PCCB CN14L for proper connection and correct as necessary.
7. PS138 I/O check, sensor check
   • Control signal: PCCB CN14L-6 (ON)
   • Location of electrical component: PC-414 4-J
8. PS139 I/O check, sensor check
   • Control signal: PCCB CN14L-3 (ON)
   • Location of electrical component: PC-414 4-J
9. M133 operation check
   • Control signal: PCCB CN10L-3 to 4
   • Location of electrical component: PC-414 6-J
10. Replace M133. (Part# A2XMM10100)
11. Replace PCCB. (Part# A7VAH00300)
12. MFPB F11E conduction check
13. Replace MFPB. (Part# A797H02118)

NOTICE

• Link to the wiring diagram (PC-414)

K.3.7.12 (Link to the Field Service Manual)