P-9 (bizhub 360i/300i)

Posted
ByAdministrator Administrator
You are here:

Please search Knowledge Base articles and Bulletins as they may contain relevant information and updated Part information such as Part numbers.

Contents

Malfunction typeDrum/Development unit (K) failure
Malfunction codeP-9
Malfunction detection timing-All density readings taken from the density pattern produced on the transfer belt are 1.0 g/m2 (IDC sensor photo receiver output) or less during max. density adjustment (Vg/Vdc adjustment).

-All density readings taken from the density pattern produced on the transfer belt are 4.0 g/m2 (IDC sensor photo receiver output) and more during max. density adjustment (Vg/Vdc adjustment).
Relevant parts-Drum unit/K
-Developing unit/K
-IDC sensor/Fr (IDCS/Fr)
-IDC sensor/Rr (IDCS/Rr)
-Base board (BASEB)
-High voltage unit (HV)
-Transfer belt unit

Procedure

  1. Check the setting value in [Max Image Density Adj] of [Service Mode] -> [Imaging Process Adjustment] and, if it is negative, readjust.
  2. Check the drive transmission portion of the drum/developing unit and correct as necessary.
  3. Clean the IDC sensor/Fr (IDCS/Fr) or IDC sensor/Rr (IDCS/Rr) window if dirty.
  4. Clean the contact of the drum/developing unit connector if dirty.
  5. Check the connector between HV CN1-BASEB CN26E for proper connection.
  6. Replace the drum unit. (Part# AAV70RD)
  7. Replace the developing unit. (Part# ACV803D)
  8. Replace the transfer belt unit. (Part# AC74R70100)
  9. Replace HV. (Part# AC77M40600)
  10. Replace BASEB. (Part# AC77H02101)

(Link to the Field Service Manual)