How Can We Help?
92-01, 92-02, 92-40 (bizhub 950i/850i)
Please search Knowledge Base articles and Bulletins as they may contain relevant information and updated Part information such as Part numbers.
Contents
JAM type | Misfeed at duplex pre-registration section | |
JAM code | 92-01, 92-02, 92-40 | |
JAM detection timing | 92-01 | The leading edge of the paper is not turned ON the registration sensor (PS38) even after the lapse of a given period of time after a duplex paper feed sequence has been started. |
92-02 | For the second-side feed of paper in the duplex mode, loop forming has not been complete before the second side of a sheet enters the registration roller because the rise timing of load to perform registration is earlier than the rise timing of load to form a loop. | |
92-40 | For the second-side feed of paper in the duplex mode, the image write start signal permit continues to be disabled for a predetermined period of time after the timing of the image write start signal output. | |
– | Paper jam of a sheet of paper left at the duplex pre-registration section results, if a sheet of paper is determined to exist at a position detected when the main power switch is turned ON, a door is opened and closed, or a misfeed or malfunction is reset. | |
Misfeed processing location | -Right door -Automatic duplex unit door | |
Relevant parts | -ADU transport motor/1 (M31) -ADU transport motor/2 (M32) -Registration sensor (PS38) -Paper feed/transport drive board (PFTDB) -Base board (BASEB) |
Procedure
Step | Action | Control signal | Location of electrical component |
---|---|---|---|
1 | Initial check items | – | – |
2 | PS38 I/O check, sensor check | PFTDB CN2-5 (ON) | 8-P |
3 | M31 load check -Check code: 85 -Multi code: 1, 2, 3, 4 | PFTDB CN28-14 to 17 | 4-P |
4 | M32 load check -Check code: 85 -Multi code: 5, 6, 7, 8 | PFTDB CN28-10 to 13 | 3-P |
5 | PFTDB F25 conduction check. | – | – |
6 | Replace PFTDB. | – | – |
7 | Replace BASEB. | – | – |