C0208 (bizhub 360i/300i)

Please search Knowledge Base articles and Bulletins as they may contain relevant information and updated Part information such as Part numbers.

When PC-216 is installed

Contents

Trouble type	C0208: Tray 4 feeder up/down abnormality (When PC-216 is installed)
Rank	B
Trouble detection condition	The tray 4 upper limit sensor (PS126) is not turned ON (blocked) even after the set period of time has elapsed after the paper lift-up operation for the drawer began.
Trouble isolation	Tray 4
Relevant electrical parts	-Tray 4 lift-up motor (M123) -Tray 4 upper limit sensor (PS126) -PC control board (PCCB) -CPU board (CPUB) -Base board (BASEB)

Procedure

1. Remove the tray and check to see if a piece of paper is not left inside the machine.
2. Check the connector between M123-PCCB CN8C for proper connection and correct as necessary.
3. Check the connector of M123 for proper drive coupling and correct as necessary.
4. Check the connector between PS126-relay CN47-PCCB CN7C for proper connection and correct as necessary.
5. Check CPUB for proper installation and correct as necessary.
6. PS126 I/O check, sensor check
   • Control signal: PCCB CN7C-3 (ON)
   • Location of electrical component: PC-216 8-K
7. M123 load check
   • Check code: 23
   • Multi code: 7
   • Control signal: PCCB CN8C-8 to 9
   • Location of electrical component: PC-216 5-K
8. Replace M123. (Part# 9J06M10300)
9. Replace PCCB. (Part# AAV5H00201)
10. Replace CPUB. (Part# AC77H02P02)
11. Replace BASEB. (Part# AC77H02101)

 When PC-417 is installed

Contents

Trouble type	C0208: Tray 4 feeder up/down abnormality (When PC-417 is installed)
Rank	B
Trouble detection condition	The tray 4 upper limit sensor (PS166) is not turned ON (blocked) even after the set period of time has elapsed after the paper lift-up operation for the drawer began.
Trouble isolation	Tray 4
Relevant electrical parts	-Tray 4 lift-up motor (M144) -Tray 4 upper limit sensor (PS166 )-PC control board (PCCB) -CPU board (CPUB) -Base board (BASEB)

Procedure

1. Remove the tray and check to see if a piece of paper is not left inside the machine.
2. Check the connector between M144-PCCB CN6 for proper connection and correct as necessary.
3. Check the connector of M144 for proper drive coupling and correct as necessary.
4. Check the connector between PS166-relay CN47-PCCB CN4 for proper connection and correct as necessary.
5. Check CPUB for proper installation and correct as necessary.
6. PS166 I/O check, sensor check
   • Control signal: PCCB CN4-3 (ON)
   • Location of electrical component: PC-417 4-C
7. M144 load check
   • Check code: 23
   • Multi code: 7
   • Control signal: PCCB CN6-9 to 10
   • Location of electrical component: PC-417 5-K
8. Replace M144. (Part# A2X0M12101)
9. PCCB PS301 conduction check
10. Replace PCCB. (Part# AAV5H01401)
11. Replace CPUB. (Part# AC77H02P02)
12. Replace BASEB. (Part# AC77H02101)

(Link to the Field Service Manual)