C6103 (bizhub 287/227)
Please search Knowledge Base articles and Bulletins as they may contain relevant information and updated Part information such as Part numbers.
Contents
| Trouble type | C6103: Slider over running |
| Rank | B |
| Trouble detection condition | The scanner home sensor (PS105) detects the scanner at its home position during a period of time that begins with the time when a prescan command and a scan preparation command are executed and ends when a home return command is executed. |
| Trouble isolation | Scanner |
| Relevant electrical parts | -Scanner home sensor (PS105) -Scanner motor (M101) -MFP board (MFPB) |
Procedure
- Correct or change the scanner drive (pulley, gear, belt) if it is faulty.
- Correct the scanner motor set screw if loose.
- Adjust [Image Position: Leading Edge] and [Sub Scan Zoom Adj.].
- Check the connector between M101-relay CN6IR-MFPB CN26E for proper connection and correct as necessary.
- Check the connector between PS105-MFPB CN27E for proper connection and correct as necessary.
- PS105 I/O check, sensor check
- Control signal: MFPB CN27E-15 (ON)
- Location of electrical component: 5-V
- M101 operation check
- Control signal: MFPB CN26E-1 to 4
- Location of electrical component: 6-W
- Replace MFPB. (Part# A7AHH0201D)
NOTICE
- Link to the wiring diagram (bizhub 367/287/227)
K.3.13.1 (Link to the Field Service Manual)